Panamax INS00809 Merkblatt

STEP 1:

Select a location close to the equipment. In the case of a flat panel 

display, the recommended location is one that is behind the device 

and hidden from view once the Plasma TV is mounted. Cut a 4” 

wide by 3 3/4” high hole in the wall for the outlet box.

STEP 2:

Run the building wire (e.g. Romex) through a rear opening in 

the outlet box (not included). No more than 1” of wire sheath 

should extend into the outlet box. 3” of wire should be able to 

extend beyond the opening of the outlet box. Install the outlet 

box in the hole.

STEP 3:

Strip building wire. Using the included wire nuts, first connect 

the ground wires - green insulated on the MlW-Power and bare 

copper on the building wire.  Then connect the neutral wires 

(white), then the hot wires (black).

STEP 4:

Neatly fold the AC wires as you install the Max In-Wall in the

outlet box and secure with the included screws.

STEP 5:

Turn the power on to the circuit. The blue Power indicator 

should light up, indicating the outlet is ready for use.

NOTES:

In the event of a hazardous voltage situation, the red Unsafe 

Voltage indicator will blink until the voltage returns to a safe level.

1

(Outlet boxes 

not included)

INS00809  REV B  06/07

CAUTION:

Only for use with 15 Amp circuits utilizing a minimum of 14 AWG.

Make sure the circuit is not live before installation. If you are unsure how 

to perform this task, please contact an electrician.

Signal Protection Module Usage:

Panamax In-Wall signal protection modules (sold separately), 

while not necessary for surge protection in the Max In-Wall

Power-Pro, may be used to provide a clean looking interface for 

the signal lines. When used in the proper manner the modules 

also provide total protection to the connected equipment.