Nortel Networks BCM1000 Benutzerhandbuch

Chapter 7 Setting media bay module DIP switches

N0008587  01

DSM32 module, because the second level of DSM lines would not be accessible. The same 
applies to assigning a DSM32 to DSM30 06 if your system is set to a 3/5 DSM30 split. Refer 
to 

 on page 104.

•

The DIP switches on the 4X16 module are used to set the DS30 bus number and offset for the 
CTM part of the module. The module automatically assigns an additional DS30 bus for the 16 
DSM lines. However, you cannot choose DS30 07 for the 4X16 module, because the DSM 
lines would not be accessible. The same applies to DS30 06 if your system is set to a 3/5 DS30 
split. Refer to 

 on page 99.

•

The CTM8 module uses two offsets on a DS30 bus. You assign the first offset to the module, 
and the second offset is automatically selected. This means that you can choose offset pairs 
0-1, 1-2, or 2-3. Because the module requires two offsets on the same DS30 bus, you cannot 
select offset 3. Refer to 

 on page 95.

•

Not all modules are available to all systems. Refer to 

 for specifics about each module.

Assign the media bay modules and DS30 bus numbers in the order shown in 

. 

Station modules are assigned starting with DS30 02. This allows telephones to start numbering 
from the system Start DN (Default: 221).

Trunk modules are assigned starting at DS30 07, in a system with a 2/6 DS30 split, and at DS30 06 
in a system with a 3/5 DS30 split. The exception to this is the 4X16 module, which requires two 
DS30 blocks, so it must be set to a DS30 bus that has the next bus open.

Remember, if you have chosen a 3/5 DS30 split for your system, DS30 07 is no 

longer available for media bay modules.