Nortel Networks BCM1000 Benutzerhandbuch
Chapter 7 Setting media bay module DIP switches
89
Installation and Maintenance Guide
Determining module DIP switch settings
After you determine in which order you want to assign the modules, you determine the specific
switch settings for each module.
switch settings for each module.
1
Use
to determine a switch setting for all modules except FEM modules.
shows an example of the table and how to do the following steps:
Step 1:
circle the module names.
Step 2:
Number the order in which you want to assign the modules.
Step 3:
Determine the number of DS30 blocks each module requires.
Step 4:
Circle the DS30 bus and offset numbers.
Step 5:
Follow the DS30 bus and offset number to the far right column where the switch
settings are indicated. Circle the setting for each module.
settings are indicated. Circle the setting for each module.
Figure 39 How to use the configuration map
Note:
If you must assign specific line or extension numbers to a module, refer to the
individual switch tables in
for line and DN listings.
DS30
bus #
Offset
Media bay module positioning
DIP switch setting
DSM
16
DSM 32 4x16 ASM
8
DTM CTM
CTM
8
BRI
1
2
3
(offset)
4
5
6
(DS30)
2
0
on on on on on on
7
0
on on on off on off
1
on on off off on off
2
on off on off on off
3
on off off off on off
1. Indicate the modules you want to install
2. Note how many DS30 bus numbers each module requires
3. Choose the DS30 blocks to
assign to the modules
assign to the modules
4. Assign an offset number to
each module
each module
5. Make a note of the DIP switch settings
for the DS30 bus #/offset
for the DS30 bus #/offset
1
2
3
4
5
5
DIP switch
setting for
offset
setting for
offset