Nortel Networks BCM1000 Benutzerhandbuch
170
Chapter 15 Preparing hardware for maintenance or upgrades
N0008587 01
Removing the front bezel
The front bezel is a plastic cover installed on the front of the BCM1000. You must remove the
bezel to add or remove the cards or the media bay modules. Refer to
bezel to add or remove the cards or the media bay modules. Refer to
1
To remove the front bezels:
Base unit: Grasp the edge of the front bezel and pull it forward.
Expansion unit: Push against the bottom of the bezel, and then pull the bezel out from the top.
Figure 75 Removing the front bezel
Restarting the system
When you finish your maintenance procedures, restart the Business Communications Manager
hardware in the order described in this section.
hardware in the order described in this section.
Restoring the system to operation
To restore the system to operation after a maintenance session, follow these steps:
1
Ensure that all cables inside the housing are connected snugly to the correct boards and excess
cable is bundled neatly, out of the way.
cable is bundled neatly, out of the way.
2
Put the bezel back on the BCM1000 or BCM1000e, if you removed it.
3
Put the lid back on the unit and replace the screws.
4
If you removed the unit from the rack or wall, replace it.
5
Plug the BCM1000e, if there is one, back into the ac power source.
6
Plug the BCM1000 back into the ac power source.
BCM1000
Grasp the edge of the front bezel and pull
it forward
it forward
BCM1000e
1. Push against the bottom
2. Pull out from the top
2. Pull out from the top