Nortel Networks BCM1000 Benutzerhandbuch
173
Installation and Maintenance Guide
Chapter 16
Replacing the hard disk
Replacing the hard disk
The BCM1000 includes either one or two factory-installed hard disks. You also can install a
second hard disk to a single-disk base unit. (Not available to BCM1000 hardware manufactured
for the BCM 2.0 release).
second hard disk to a single-disk base unit. (Not available to BCM1000 hardware manufactured
for the BCM 2.0 release).
This chapter explains how to change a hard disk, and how to upgrade a single-disk system to a
mirrored system by adding a RAID board and a second hard disk.
mirrored system by adding a RAID board and a second hard disk.
provides an overview of the hard disk replacement process.
Figure 76 Process map: Hard disk replacement
If possible,
Note positioning of power and ribbon cables
Connect power and ribbon cables.
WARNING:
Test all functions
Perform disk
Single Disk
System
Mirrored Disk
System
Remove the damaged hard disk from the brackets
in the brackets, ensuring
is on the bottom
Reconnect hard disk
cable to controller
to operation
Upgrading to
mirrored disk