Nortel Networks BCM1000 Benutzerhandbuch
218
Chapter 19 Replacing data cards and processing hardware
N0008587 01
Removing a data card
Five LEDs on the front of the BCM1000 indicate PCI card status. LAN cards can be inserted any
of the first three PCI slots. Refer to
of the first three PCI slots. Refer to
lists the various LED states.
Figure 126 BCM1000 LAN card LEDs
Note:
There are four possible profiles for data card placement in the BCM1000.
shows the configuration for profile 1. Note that the WAN card is connected to
the first two PCI LEDs.
If the data card placement on your base unit differs, ensure that you replace the cards in the
same slots they were removed from. Not all systems can support all cards.
same slots they were removed from. Not all systems can support all cards.
Table 44 BCM1000 PCI LED states
LED
Label
Description
Green LED On
Green LED Flash
Green LED Off
1
PCI Device/
WAN Port #1
WAN Port #1
Device is present. Driver is active
Driver is not running
Device is not present.
2
PCI Device/
WAN Port #2
WAN Port #2
Device is present. Driver is active
Driver is not running
Device is not present.
3
PCI Device
Device is present. Driver is active
Driver is not running
Device is not present.
4
PCI Device
Device is present. Driver is active
Driver is not running
Device is not present.
5
PCI Device
Device is present. Driver is active
Driver is not running
Device is not present.
Note: The MSC is not field-replaceable
PCI Device s