Nortel Networks BCM1000 Benutzerhandbuch

Chapter 20 Moving and replacing telephones

N0008587  01

You can move an Business Communications Manager digital telephone to a new location within 
the system without losing its programmed settings if the telephone has been enabled with 
Set relocation in system programming under Feature programming. When you enable Set 
relocation (automatic telephone relocation), the internal numbers, autodial settings, and personal 
speed dial codes remain with the telephone when you disconnect the telephone. 

If you connect a different telephone to the jack before you reconnect the moved telephone, the new 
telephone takes the programmed settings. The Business Communications Manager system can no 
longer identify the old telephone.

After you plug a moved set into a new jack, the Business Communications Manager system can 
take 45 seconds to identify the telephone. Programming relocation takes three minutes to 
complete. Wait for this to occur before you change any settings for the telephone in the system.

For IP telephones to retain features, the Keep DN Alive setting for the telephone programming 
must be set to Yes in system programming on the Capabilities screen in the DN record for the 
telephone.

If

If you disconnect a relocated telephone before the relocation programming is 

complete, the telephone can lose the programmed settings.

Automatic telephone relocation is disabled by default.