Nortel Networks BCM1000 Benutzerhandbuch
Chapter 2 Telephony hardware
47
Installation and Maintenance Guide
Global Analog Station media bay module (GASM8)
The Global Analog Station media bay module (GASM8) provides the same functionality as the
ASM8 with the addition of the following features:
ASM8 with the addition of the following features:
•
support for calling line identification pass-through
•
the option to activate disconnect supervision at the device
•
the ability to pass a voice mail message indicator signal to activate a message waiting lamp on
the telephone, if it has one
the telephone, if it has one
•
support for an Off Premise Extension (OPX).
The GASM8 has one amphenol connector on the faceplate. For details about wiring the GASM8,
refer to
refer to
.
Ringer Equivalency (REN) for each module is 2 (two).
NOTE: The termination on the analog interface may consist of any combination of devices subject
only to the requirement that the sum of the RENs of all the devices does not exceed the REN of the
interface to which the device is connected. The ringer equivalency number, per port, for this
module, is 1 (one).
only to the requirement that the sum of the RENs of all the devices does not exceed the REN of the
interface to which the device is connected. The ringer equivalency number, per port, for this
module, is 1 (one).
The back of the GASM8 has two sets of DIP switches. The first set defines the DS30 bus and
offset. The second set determines if the module allows an automatic firmware download from the
system (BCM 3.6 software) or which country firmware the module will use. Refer to
offset. The second set determines if the module allows an automatic firmware download from the
system (BCM 3.6 software) or which country firmware the module will use. Refer to
.
Specialized media bay modules
This section describes the modules that perform a specific job outside of the trunk and station
description. Refer to
description. Refer to
•
The Fiber Expansion module (FEM), provides a fast way of upgrading from an existing
Norstar system simply by plugging in Norstar expansion modules to the FEM box.
Norstar system simply by plugging in Norstar expansion modules to the FEM box.
•
The DDI MUX module allows you to combine data and telephone trunks through one T1
interface.
interface.
Table 7 Specialized modules
Module type
What it does
Special notes
FEM
connects a maximum of six Norstar expansion
modules
modules
The switches on the FEM are used to
turn fiber ports on and off. The FEM
does not work correctly if you set these
switches using the rules used for other
media bay modules.
turn fiber ports on and off. The FEM
does not work correctly if you set these
switches using the rules used for other
media bay modules.