Panasonic TQBJ0349 Benutzerhandbuch

About Your Projector

ENGLISH -

Preparation

Setting projector ID number

to remote control

Each projector can be assigned a unique ID number,

and the handheld remote’ s number must be set to

match the intended projector.

The ID number of the projector is set to “ALL” on

shipping, and use the ID ALL button of the remote

control when using only a single projector.

Press <ID SET> button, and the

1 )

projector (s) will display it’s current ID

number onscreen. Within 5 seconds,

use the numeric keys (1-6) to match

the Remote’s ID number with that of

the desired projector.

Attention

Do not press <ID SET> button accidentally or carelessly

because the ID number on the remote control can be set

even when no projector is around.

If you do not enter the 1 digit ID number within 5 seconds

after <ID SET> button has been pressed, the ID will

remain at the number that was set before <ID SET>

button was pressed.

Your specified ID number is stored in the remote control

unit unless another one is specified later. However, the

stored ID will be erased if the batteries of the remote

control are left exhausted. When the batteries are

replaced, set the same ID number again.

Note

Refer to