Panasonic D6KE Benutzerhandbuch

 Switching on the projector

When using an optional lens, install a projection lens 
before switch on the projector.

1. Connect the supplied mains lead (220 - 240 V AC, 

50 Hz/60 Hz) to the AC IN terminal.

2. Remove the projection lens cover from the lens.
3. Switch the POWER switch on that is on the side of the 

projector.



The power indicator lamp on the projector will flash in red. 
After a short period, the indicator will illuminate and the 
projector will enter standby mode.

4. Press the POWER ON button



The power indicator lamp illuminates in green and soon the 
image is projected on the screen.

.

 Making adjustment and selection

It is recommended that the projector be allowed to warm 
up for at least 30 minutes before any adjustments are 
made to the focus.

1. Roughly adjust the focus of the lens.
2. Select and set the projection scheme of 

 and COOLING CONDITION settings in 

 menu.

3. Select the input signal by pressing the INPUT SELECT 

buttons.

4. Adjust the vertical tilt of the projector with the front leg 

adjusters.

5. Adjust the shift position of the projection.



If the input signal is RGB signal, additionally press the 
AUTO SETUP

 button to adjust the position of the image.

6. Zoom the lens so the image fills the screen.
7. Readjust the focus.
8. Readjust the zoom so that the image size fits in the 

screen.

 Adjusting focus, zoom and shift

• If the projector is powered up at about 

0 °C (32 °F)

, a warm-

up period of approximately 5 minutes may be necessary to 
start projection. The temperature monitor (TEMP) lamp lights 
up during the warm-up period. When the warm-up is 
completed, the temperature monitor (TEMP) lamp turns off 
and the image is projected on the screen.

• If the temperature of the operating environment is low and 

warm-up takes more than 5 minutes, the projector will judge 
that a problem has occurred and the power will be turned off 
automatically. If this happens, increase the temperature 
around the projector so that it is 

0 °C (32 °F)

 or higher, and 

then turn on the POWER switch and press the POWER ON 
button again.

 switch

 terminal

 button

Pressing the LENS button changes the 
setup screen in order of FOCUS, ZOOM 
and SHIFT. Press F G I H to adjust.

Press FOCUS, ZOOM or SHIFT button 
to display the setup screen. Press F G 
I H to adjust.

• Be careful not to catch your fingers between the lens and 

shroud when shifting the lens.

• The setup screen will be displayed with the optional fixed lens 

though, it will not be functioning.

• Pressing F G I or H for 3 seconds or more, performance 

the adjustment faster.

 button

 buttons