Panasonic D6KE Benutzerhandbuch

Do not reach for the openings beside the optical 
lens, during horizontal or vertical movements of the 
lens.


Failure to observe this may cause injury.

Replacement of the lamp unit should only be carried 
out after it has completely cooled off.


Failure to observe this may cause burns.

Do not subject the projector to excessive vibration 
or shocks.


The projector lens need to be handled with care.



Cover the lens with the lens cover when transporting 
the projector.

When transporting the projector, hold the body at 
the bottom securely.


Do not hold the adjuster legs or the top cover to move 
the projector, as this may damage the projector.

Be sure to always remove the lens during transport.


The projection lens is susceptible to vibrations and 
impacts.

Avoid setting up in places which are subject to 
vibration or shocks.


The internal parts can be damaged, which may cause 
malfunctions or accidents.

Avoid setting up in places which are subject to 
sudden temperature changes, such as near an air 
conditioner or lighting equipment.


The life of the lamp may be shortened or the projector 
may be turned off. See “TEMP indicator” on page 28.

Do not set up the projector near high-voltage power 
lines or near motors.


The projector may be subject to electromagnetic 
interference.

If installing the projector to the ceiling, ask a 
qualified technician to carry out all installation work.


You will need to purchase the separate installation kit 
(Model No. ET-PKD56H, ET-PKD55S). Furthermore, 
all installation work is should only be carried out by a 
qualified technician.

If using this projector at high elevations 1 400 - 
2 700 m (4 593 - 8 858 ft) sea level, set the HIGH 
ALTITUDE MODE to ON.


Failure to observe this may result in malfunctions or 
the life of the lamp or the other components may be 
shortened.

Be sure to install the projection lens cover after 
installing the projection lens.


If this not done, dust will collect inside the projector 
and problems with the projector will result.

In order to get the best picture quality


Draw curtains or blinds over any windows and turn off 
any lights near the screen to prevent outside light or 
light from indoor lamps from shining onto the screen.



In rare cases, wafture can occur on the screen 
affected by the warm air from the exhaust port 
depending on the environment. Make sure that there 
is no equipment in front of the set which will 
recirculate the exhaust air from the set or other 
nearby equipment.

Do not touch the surfaces of the lens or the front 
glass with your bare hands.


If the surface of the lens becomes dirty from 
fingerprints or anything else, this will be magnified 
and projected onto the screen. Moreover, when not 
using the projector, close the front panel cover.