Panasonic PT-AE3000E Benutzerhandbuch
E
NGLISH - 11
Prep
arat
ion
About Your Projector
Remote control
NOTE:
• Do not drop the remote control.
• Avoid contact with liquids or moisture.
• Use manganese batteries or alkaline batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• See “Remote control operation” on page 23.
• Avoid contact with liquids or moisture.
• Use manganese batteries or alkaline batteries with the remote control.
• Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
• Do not keep pressing the remote control buttons as this may shorten battery life.
• See “Remote control operation” on page 23.
Battery compartment
1. Press the tab and lift up the cover.
2. Insert the batteries according to the polarity diagram indicated
1. Press the tab and lift up the cover.
2. Insert the batteries according to the polarity diagram indicated
inside.
Power button
While the MAIN POWER
button is on, switch between
standby mode and projection
mode. (page 21)
While the MAIN POWER
button is on, switch between
standby mode and projection
mode. (page 21)
Remote control signal emitter
Emit remote control signal. (page 23)
Emit remote control signal. (page 23)
Button backlight
When any button is pressed, the button
backlight is lit. Without any operation, it
gets darker after 5 seconds and goes off
after next 5 seconds.
When any button is pressed, the button
backlight is lit. Without any operation, it
gets darker after 5 seconds and goes off
after next 5 seconds.
Switch to cycle through the
PICTURE MODE. (page 23)
PICTURE MODE. (page 23)
Switch to cycle through the
aspect ratio. (page 24)
aspect ratio. (page 24)
Reset some of the settings to
the factory default. (page 28)
the factory default. (page 28)
Display the LENS CONTROL
menu. (page 23)
menu. (page 23)
Display the MEMORY LOAD
menu. (page 24)
menu. (page 24)
Display the input waveform.
(page 24)
(page 24)
Return to the previous
menu. (page 29)
menu. (page 29)
Capture the projected image
as a still image. (page 28)
as a still image. (page 28)