PLUS Vision KG-PS120X Benutzerhandbuch

When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook
computer startup procedure as well as the operation that follows notebook startup. Please consult the instruction manual of your
notebook computer or the on-line help while performing the following procedure.

Check whether a signal is being sent from the notebook computer to the projector.
An indication appearing on the liquid crystal display of the notebook computer does not necessarily mean that an external
output signal is being output.
REFERENCE: When “Resolution” or “Frequency” is not displayed under “Info.” on the menu of the projector, this means that
the external output signal is not being output from the personal computer. See “Resolution/Frequency” on Page E-64.

Should a sign not be output from the notebook computer, please try the operation described below.
For an IBM PC/AT compatible computer, press the [Fn] key plus any one of the [F1] to [F10] keys. (See the table below.)

Note:
When the liquid crystal display of the notebook computer and the projector are displayed at the same time, the projected image might not be
correct even though the liquid crystal display shows a correct indication. Should this occur, stop the simultaneous display of the notebook
computer and try the mode with external output only. Try an operation such as that described in aforementioned Step 2 and try closing the
liquid crystal panel which might result in external output only.

DELL

All computers

Fn + F8

EPSON

All computers

Fn + F8

FUJITSU

All computers

Fn + F10

MITSUBISHI

All computers

Fn + F5

IBM

All computers

Fn + F7

NEC

All computers

Fn + F3

Panasonic

All computers

Fn + F3

SHARP

All computers

Fn + F5

SONY

All computers

Fn + F7

SOTEC

All computers

Fn + F3–F5

TOSHIBA

All computers

Fn + F5

HITACHI

All computers

Fn + F7

Note: Table information is current to December 2006.