NEC NP405 Betriebsanweisung

2. Installation and Connections

COMPUTER 1 IN

COMPUTER 2 IN

AUDIO IN

PHONE

IBM VGA or Compatibles (Notebook
type) or Macintosh (Notebook type)

VGA signal cable (supplied)

To mini D-Sub 15-pin connector on
the projector. It is recommended that
you use a commercially available
distribution amplifier if connecting a
signal cable longer than the cable
supplied.

NOTE: For older Macintosh, use a commercially available

pin adapter (not supplied) to connect to your Mac’s video

port.

Audio cable
(not supplied)

 Making Connections

NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode

and before turning on the power to the notebook PC.

In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.

* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power manage-

ment software.

Enabling the computer’s external display

Displaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually, the combination of the “Fn” key along with one of the 12 function keys gets the external display to come on
or off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle through
external display selections.

Connecting Your PC or Macintosh Computer

NOTE: Signals supported by Plug & Play (DDC2)

Model

INPUT

COMPUTER 1 IN

COMPUTER 2 IN

analog

digital

NP610/NP510/NP410/NP310/

NP510W/NP410W/NP610S/NP510WS

Yes

NP405/NP305

Yes

—

NP405/NP305