NEC NP405 Betriebsanweisung
38
3. Projecting an Image (Basic Operation)
7 Turning off the Projector
MENU
EXIT
ENTER
STATUS
LAMP
AUTO ADJ.
SOURCE
ENTER
EXIT
MENU
UP
MAGNIFY
PAGE
OFF
POWER
ON
AV-MUTE
DOWN
To turn off the projector:
1. First, press the
(POWER) button on the projector
cabinet or the POWER OFF button on the remote con-
trol.
trol.
The [POWER OFF / ARE YOU SURE? / CARBON SAV-
INGS- SESSION 0.000[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the
(POWER) or the POWER OFF button again.
The lamp will turn off and the projector will go into standby
mode. When in standby mode, the POWER indicator will
light orange and the STATUS indicator will light green when
[NORMAL] is selected for [STANDBY MODE].
light orange and the STATUS indicator will light green when
[NORMAL] is selected for [STANDBY MODE].
Immediately after turning on the projector and displaying an
image, you cannot turn off the projector for 60 seconds.
3. Finally, turn off the Main Power switch.
The POWER indicator will go out.
The POWER indicator will go out.
NOTE: Do not turn off the main power within 10 seconds of making
adjustment or setting changes and closing the menu.
Doing so can cause loss of adjustments and settings.
Power On
Steady green
light
CAUTION:
Parts of the projector will become heated during operation. Use caution when picking up the projector immediately
after it has been operating.
after it has been operating.
CAUTION:
The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is
blinking green. Doing so could cause premature lamp failure.
blinking green. Doing so could cause premature lamp failure.
Standby
Steady
orange light