Compaq S0000 / 8000 Benutzerhandbuch
104 user’s guide
•
If you are replacing a memory module, put the new memory module in the
same memory slot from which the old memory was removed.
same memory slot from which the old memory was removed.
•
If you are adding a memory module, install the new module into the socket
nearest the preinstalled module, and install additional modules in the next
available sockets.
nearest the preinstalled module, and install additional modules in the next
available sockets.
2 The memory module can be installed in only one way. Match the notch on the
module (1) with the tab on the memory socket. Push the module carefully and
firmly into the slot, ensuring that the latches (2) on both ends snap into place.
firmly into the slot, ensuring that the latches (2) on both ends snap into place.
installing a memory module
3 Complete the procedure described in “reassembling the pc“ on page 107.
NOTE:
If a blank screen is displayed after replacing or adding a memory
module, the memory is installed incorrectly or it is the wrong type of memory.
Remove and reinstall the memory module.
Remove and reinstall the memory module.
removing or installing an expansion card
An expansion card is a circuit board that fits into a PC expansion slot. Your PC
contains several expansion slots that can be used to add components to your PC.
Component configurations vary by model.
contains several expansion slots that can be used to add components to your PC.
Component configurations vary by model.
Expansion cards you can replace or add to your PC include:
•
Modem
•
Network Interface Card (NIC)
•
Graphics Card
•
Sound Card
•
FireWire (IEEE 1394) Auxiliary Card
A Phillips screwdriver is needed to remove, replace, or add an expansion card.