Festool Plunge Router I Benutzerhandbuch

 

 

 

This section provides a 

quick overview of the 

components and features 

of the OF 1400 EQ router. 

Additional information 

about these components 

and features will be 

discussed later in the 

manual. 

 

 

6 

OF 1400 EQ Router 

Figure 1 
a.  Trigger (On/Off Switch). Used to turn the router On and 

Off. 

b.  Trigger Lock. This locks the power trigger in the On 

position.  

c.  Speed Control. This dial is used to change the motor 

speed of the router. The higher the number, the faster the 

motor speed. 

d.  Depth Stop Post Handle. The depth stop post is raised or 

lowered with this handle. 

e.  Plunge Depth Gauge. Indicates the depth of plunge. This 

is used in conjunction with the other depth setting 

features to determine the depth of plunge. 

f.  Plunge Depth Pointer. This sliding pointer is used to set 

the plunge depth relative to a basepoint setting. 

g.  Plunge Stop Micro-adjust Knob. The micro adjustment 

knob is used to fine tune a depth setting by small 

increments. 

h.  Plunge Lock Knob. This dual action knob acts as an 

auxiliary handle for the router, and also clamps the 

router in a fixed-plunge position.  

i.  Depth Post Lock. This lever locks the depth post in 

position.  

j.  Depth Stop Turret. The turret allows for three rapid-

change depth settings based on a single depth stop. Each 

position can be adjusted for individual depth. 

k.  Accessory Latches (2). The accessory latches are used to 

secure optional accessories below the base of the router, 

such as a template guide.  

l.  Outrigger Clamping Knob. The clamping knob is used 

to secure outrigger accessories to the router base, such as 

an edge guide accessory.  

m. Dust Collection Port. The removable dust collection port 

can be connected to a vacuum system for chip removal. 

n.  Dust Collection Port Latch. The latch secures the dust 

collection port in position. 

o.  Ratcheting Spindle Lock. The spindle lock stops the 

shaft from turning during a bit change. The dual action 

lever locks the spindle in one direction and ratchets in the 

opposite direction for faster bit changing. Press the lever 

on the left to tighten the collet nut, and press it on the 

right to loosen the collet net. 

p.  Collet. The collet holds router bits in place.