Accton Technology 12i Benutzerhandbuch

Disabling a port is the same as manually partitioning it,

except that you must also manually reconnect it.  For example,
to prevent a certain device from accessing the network or to
reduce network traffic you may opt to disable the port.  No
incoming packet transmission can occur on a disabled port.
Ports can be disabled/enabled using the on-board configuration
program or via optional network management software.  They
can also be enabled by restarting the system, which restores the
factory default settings.

F

The Partition/Disable LEDs are also used as diagnostic LEDs.
Please refer to 

Diagnostic Test Indicators for more information.

There are 12 pairs of port status indicators.  Each pair consists
of a 

Link/Activity

 LED (in the top row) and 

Partition/Disable

LED (in the bottom row).  The last pair displays status for both
the 12MDI-X and 12MDI port, either of which is currently in
use.  Also note that port status for the memory extender
modules is displayed directly on the module as described in the
section on 

SmartExtender Module Indicator

 earlier in this chapter.

Color: Green
Label:

Link/Traffic

Function:

Indicates port link and activity.

ON

Indicates a valid link has been established on this port.

OFF

No valid link has been established on this port.

BLINKING

Indicates that the port is receiving packets; rate of blinking corresponds
to amount of traffic passing through this port.