Texas Instruments XIO3130 EVM Datenbogen
ExpressCard-Mode operation
www.ti.com
Figure 1-8. ExpressCard Adapter Board
To configure the XIO3130 EVM for ExpressCard-mode operation, connect the ribbon cable connector from
J1 on the adapter board to one of the matching connectors (J2, J3 or J4) on the XIO3130 EVM board.
Then plug the adapter board into the adjacent PCIe slot as shown in
J1 on the adapter board to one of the matching connectors (J2, J3 or J4) on the XIO3130 EVM board.
Then plug the adapter board into the adjacent PCIe slot as shown in
. It does not matter which
PCIe slot is used, but the ribbon cable must be plugged into the connector just below and to the right of
the PCIe slot that the adapter board is plugged into.
the PCIe slot that the adapter board is plugged into.
6
XIO3130 EVM
SLLU108 – July 2008