IBM Partner Pavilion BMD00082 Benutzerhandbuch
SmartConnect User’s Guide
BMD00082, February 2009
Chapter 2: Getting Started with the Browser-Based Interface
23
3.
In the Update Image/Cfg section, use the Method to use for transfer drop-down list to
specify the desired method.
specify the desired method.
4.
Get the image from the appropriate source:
If loading a software image to a TFTP server, enter the Server IP Address, and the Remote
File Name. Then click Put Image.
File Name. Then click Put Image.
If loading a software image to a FTP server, enter the Server IP Address, and the Remote
File Name. Also enter the FTP Username and FTP Password. Then click Put Image.
File Name. Also enter the FTP Username and FTP Password. Then click Put Image.
If loading a software image to a local computer (HTTP), click Browse. In the File Upload
dialog, select the desired file and click OK. Then click Put Image.
dialog, select the desired file and click OK. Then click Put Image.
Selecting a Configuration Block
When configuration changes are made to the
switch
, the administrator must save the changes so
that they are retained beyond the next time the switch is reset. When the save command is
issued, the new configuration changes are placed in the active configuration block. The previ-
ous configuration is copied into the backup configuration block.
issued, the new configuration changes are placed in the active configuration block. The previ-
ous configuration is copied into the backup configuration block.
There is also a factory configuration block. This holds the default configuration of the VSE
SmartConnect software. Under certain circumstances, it may be desirable to reset the switch
software to its default configuration.
SmartConnect software. Under certain circumstances, it may be desirable to reset the switch
software to its default configuration.
Perform the following steps to select which configuration block the switch will load the next
time it is reset:
time it is reset:
1.
On the BBI, choose menu System Settings > Boot Management > General.
2.
In the Boot Management window, select an option in the Next boot config block
(active, backup, or factory).
(active, backup, or factory).
Note –
When resetting the switch to its factory default configuration, the switch will retain its
stacking settings. To reconfigure or disable stacking, see
3.
Click Apply to submit the configuration block changes to the switch.
The changes will remain pending until the switch is next reset.
4.
Click Reboot the Module to activate the new configuration block.