IBM Partner Pavilion BMD00082 Benutzerhandbuch
SmartConnect User’s Guide
BMD00082, February 2009
Chapter 6: Configuring Switch Access
77
Protected Mode
Protected Mode settings allow the switch administrator to block the management module from
making configuration changes that affect switch operation. The switch retains control over
those functions.
making configuration changes that affect switch operation. The switch retains control over
those functions.
The following management module functions are disabled when Protected Mode is turned on:
External Ports: Enabled/Disabled
External management over all ports: Enabled/Disabled
Restore Factory Defaults
New Static IP Configuration
In this release, configuration of the functions listed above are restricted to the local switch
when you turn Protected Mode on. In future releases, individual control over each function
may be added.
when you turn Protected Mode on. In future releases, individual control over each function
may be added.
Note –
Before you turn Protected Mode on, make sure that external management (Telnet)
access to one of the switch’s IP interfaces is enabled: System Settings > Global > Switch IP
Interface.
Interface.
To configure Protected Mode, enable the functions for which you wish to secure local control,
and set Local Protected Mode to on.
and set Local Protected Mode to on.
Figure 6-C
Switch Protected Mode Configuration Window
If you lose access to the switch through the external ports, use the console port to connect
directly to the switch, and configure an IP interface with Telnet access.
directly to the switch, and configure an IP interface with Telnet access.