Intel 10/100 Benutzerhandbuch

43

C H A P T E R

3

start-fg <dport-bitmask> <count> <rate>

Starts frame generation. 

 is a hex bitmask of the ports

to generate traffic on. For example, a 

 of 3E sends

frames to ports 2, 3, 4, 5, 6. The 

 specifies the number of frames

to send on each port. A count of 0 sends packets until you type the

stop-fg

 command. The 

 specifies the number of packets per

second to generate.

Stops the frame generator.

This section lists the available IP commands. In the sections that
follow, IP Configuration lists general configuration commands, Ping
lists commands that describe the ping ability of the agent, and
Address Resolution Protocol lists ARP commands.

Displays the switch’s current IP address:

SYS_console> get-ip

 The device IP address is: 192.001.001.064

SYS_console> _

If the switch doesn’t have an IP address assigned:

SYS_console> get-ip

 The device has no IP address defined.

Displays the complete current IP configuration: IP address, netmask
(subnet mask), and broadcast address (default gateway).

SYS_console> get-ip-conf

 The device IP address, netmask and broadcast are:

            IP address   : 192.001.001.064

            IP netmask   : 255.255.255.000

            IP broadcast : 192.001.001.255