IBM 12.1(22)EA6 Benutzerhandbuch
16-7
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 16 Configuring UDLD
Displaying UDLD Status
You can also bring up the interface by using these commands:
•
The shutdown interface configuration command followed by the no shutdown interface
configuration command restarts the disabled interface.
configuration command restarts the disabled interface.
•
The no udld {aggressive | enable} global configuration command followed by the udld
{aggressive | enable} global configuration command re-enables UDLD globally.
{aggressive | enable} global configuration command re-enables UDLD globally.
•
The no udld port interface configuration command followed by the udld port [aggressive]
interface configuration command re-enables UDLD on the specified interface.
interface configuration command re-enables UDLD on the specified interface.
•
The errdisable recovery cause udld global configuration command enables the timer to
automatically recover from the UDLD error-disabled state, and the errdisable recovery interval
interval global configuration command specifies the time to recover from the UDLD error-disabled
state.
automatically recover from the UDLD error-disabled state, and the errdisable recovery interval
interval global configuration command specifies the time to recover from the UDLD error-disabled
state.
Displaying UDLD Status
To display the UDLD status for the specified interface or for all interfaces, use the show udld
[interface-id] privileged EXEC command.
[interface-id] privileged EXEC command.
For detailed information about the fields in the display, see the command reference for this release.