DELL 9.8(0.0) Benutzerhandbuch
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
S4820T
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join
Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave
Enter the keyword leave then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is 600 milliseconds.
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all
Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults
As above.
Command
Modes
Modes
CONFIGURATION-GVRP
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000–ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
GARP VLAN Registration (GVRP)
735