Q-Logic SN0135524-00 Benutzerhandbuch
QL
OGIC
S
WITCH
I
NTEROPERABILITY
G
UIDE
P
AGE
121
V
ERSION
1.0, M
ARCH
2003
IBM eServer BladeCenter
Fibre Channel Switch Module
Integration Checklist
The following steps must be completed to successfully merge IBM BladeCenter and QLogic fabrics.
The remainder of this section provides detailed instructions and examples.
The remainder of this section provides detailed instructions and examples.
ATTENTION!!
■
Backup the current configuration prior to performing the following steps so that the
configuration is available if something goes wrong.
configuration is available if something goes wrong.
■
Disruptions in the fabric can occur as a result of performing the following steps. Therefore,
it is recommended that these changes be done during down time or off-peak hours.
it is recommended that these changes be done during down time or off-peak hours.
✓
Verify that the correct version of switch firmware is installed on each switch
✓
✓
.
✓
Ensure that all Zone set and Zone names are unique and conform to ANSI T11 standards
.
✓
Ensure that all QLogic switches are configured for Merge Active Zonesets Only or SW2 mode,
as appropriate
as appropriate
.
✓
Verify that the fabrics have successfully merged
.
Configuration Limitations
No limitations exist when merging IBM BladeCenter and QLogic fabrics; all features are fully
supported and comply with industry standards.
supported and comply with industry standards.