Q-Logic SN0135524-00 Benutzerhandbuch
IBM eServer BladeCenter Fibre Channel Switch Module
Zone Configuration
QL
OGIC
S
WITCH
I
NTEROPERABILITY
G
UIDE
P
AGE
137
V
ERSION
1.0, M
ARCH
2003
Zone Configuration
This section discusses configuring active Zone Set names and Zone types.
Active Zone Set Names
The Zone and Zone Set names on each switch must be unique. If not, change one of the duplicate
names. All Zone Set and Zone names must conform to the Fibre Channel (FC) Standards for Zone
Naming (ANSI T11/00-427v3):
names. All Zone Set and Zone names must conform to the Fibre Channel (FC) Standards for Zone
Naming (ANSI T11/00-427v3):
1. Must be 1–64 characters in length.
2. All characters are ASCII.
3. First character is [a–z] or [A–Z].
4. All other characters must be [a–z], [A–Z], [0–9], or the _ character. Other characters ($-^) may
not be supported by all vendors and should be avoided.
IBM eServer BladeCenter SAN Utility
1. Start the IBM eServer BladeCenter SAN Utility. The IBM BladeCenter SAN
Utility—Faceplate dialog box displays.
2. From the IBM BladeCenter SAN Utility—Faceplate dialog box Zoning menu, select Edit
Zoning.