National Instruments 1192 Benutzerhandbuch
Chapter 1
Installing and Configuring the SCXI-119X
© National Instruments Corporation
1-11
Self-Test Verification
To test the successful configuration of your system, complete the following
steps:
steps:
1.
Double-click the Measurement & Automation Explorer icon on
your PC desktop.
your PC desktop.
2.
Verify that the chassis power is on and that the chassis is correctly
connected to a DAQ device or computer-based instrument.
connected to a DAQ device or computer-based instrument.
3.
Expand Devices and Interfaces.
4.
From the list of devices and interfaces that appears, locate the chassis
you want to test. Right-click on the chassis and select Test. If the
communication test is successful, a message
you want to test. Right-click on the chassis and select Test. If the
communication test is successful, a message
The chassis has
been verified
appears.
5.
Click OK.
Note
If the communication test is unsuccessful, refer to the Troubleshooting Self-Test
Verification
section.
Your SCXI system should now operate properly with your ADE software.
If you experience problems between your SCXI system and your ADE,
refer to the Troubleshooting Self-Test Verification
If you experience problems between your SCXI system and your ADE,
refer to the Troubleshooting Self-Test Verification
section. Additionally,
you may find it helpful to refer to your NI-SWITCH documentation,
your ADE software documentation, and your chassis documentation.
National Instruments documentation is available to download free at
your ADE software documentation, and your chassis documentation.
National Instruments documentation is available to download free at
ni.com/manuals
Troubleshooting Self-Test Verification
If the preceding test did not verify your chassis configuration, take the
following steps to successfully complete system configuration:
following steps to successfully complete system configuration:
•
If you get the warning message
Unable to test chassis at this
time
, verify that you have designated a module as being connected to
a DAQ device or computer-based instrument. Take the following
troubleshooting actions:
troubleshooting actions:
a.
Double-click the Measurement & Automation Explorer icon
on your PC desktop.
on your PC desktop.
b.
Expand Devices and Interfaces.
c.
Expand your SCXI chassis to show all the SCXI modules.
d.
Right-click the module that is connected to your DAQ device or
computer-based instrument and select Properties.
computer-based instrument and select Properties.