3com 3C17204 Benutzerhandbuch
18
C
HAPTER
1: I
NTRODUCING THE
S
UPER
S
TACK
3 S
WITCH
4400
Default Settings
Table 6 shows the default settings for the Switch 4400:
Table 6 Default Settings
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize
the Web interface or by entering system control initialize
in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
you to connect to and manage the Switch:
■
IP Address
■
Subnet Mask
■
Default Router
Feature
Switch 4400
Automatic IP Configuration
Enabled
Port Status
Enabled
Port Speed
10/100 Mbps ports are auto-negotiated
Duplex Mode
All fixed 10BASE-T and 100BASE-TX ports are
auto-negotiated
auto-negotiated
Flow Control
■
Enabled in half duplex
■
Auto-negotiated in full duplex
Broadcast Storm Control
Enabled
Virtual LANs (VLANs)
All ports belong to the untagged Default VLAN
(VLAN 1) with 802.1Q learning operational
(VLAN 1) with 802.1Q learning operational
IP Multicast Filtering
Filtering enabled
Rapid Spanning Tree Protocol Enabled
Fast Start:
■
Enabled on front panel ports
■
Disabled on rear panel port
RMON Alarm
Enabled
Smart Auto-Sensing
Enabled
Webcache Support
Disabled
Quality of Service (QoS)
All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to “best effort” for all other traffic.
All ports set to “best effort” for all other traffic.
17204ua.book Page 18 Monday, August 13, 2001 11:28 AM