Enterasys Networks D2G124-12P Benutzerhandbuch
show port trap
4-20 Port Configuration
show port trap
Use this command to display whether the port is enabled for generating an SNMP trap message if
its link state changes.
its link state changes.
Syntax
show port trap [port-string]
Parameters
Defaults
If port‐string is not specified, the trap status for all ports will be displayed.
Mode
Switch command, read‐write.
Example
This example shows how to display link trap status for
ge
.3.1 through 4:
D2(su)->show port trap ge.3.1-4
Link traps enabled on port ge.3.1.
Link traps enabled on port ge.3.2.
Link traps enabled on port ge.3.3.
Link traps enabled on port ge.3.4.
Link traps enabled on port ge.3.1.
Link traps enabled on port ge.3.2.
Link traps enabled on port ge.3.3.
Link traps enabled on port ge.3.4.
set port trap
Use this command to enable of disable ports for sending SNMP trap messages when their link
status changes.
status changes.
Syntax
set port trap port-string {enable | disable}
For information about...
Refer to page...
port‐string
(Optional) Displays link trap status for specific port(s). For a detailed
description of possible port‐string values, refer to “
description of possible port‐string values, refer to “