Enterasys Networks D2G124-12P Benutzerhandbuch

Factory Default Settings

1-2 Introduction

•

Remotely using WebView™, Enterasys Networks’ embedded web server application.

The Installation Guide for your D‐Series device provides setup instructions for connecting a 
terminal or modem to the switch.

The following tables list factory default settings available on the D‐Series switch. 
Table 1-1 Default Settings for Basic Switch Operation

CDP discovery protocol

Auto enabled on all ports.

CDP authentication code

Set to 00-00-00-00-00-00-00-00

CDP hold time

Set to 180 seconds.

CDP interval

Transmit frequency of CDP messages set to 60 seconds.

Cisco discovery protocol

Auto enabled on all ports.

Cisco DP hold time

Set to 180 seconds.

Cisco DP interval timer

Set to 60 seconds.

Community name

Public.

Console (serial) port 
required settings

Baud rate: 9600
Data bits: 8 
Flow control: disabled
Stop bits: 1
Parity: none

DHCP server

Disabled.

EAPOL

Disabled.

EAPOL authentication 
mode

When enabled, set to auto for all ports.

GARP timer

Join timer set to 20 centiseconds; leave timer set to 60 centiseconds; leaveall 
timer set to 1000 centiseconds.

GVRP

Globally enabled.

History buffer size

20 lines.

IEEE 802.1 authentication

Disabled.

IGMP snooping

Disabled. When enabled, query interval is set to 260 seconds and response 
time is set to 10 seconds.

IP mask and gateway

Subnet mask set to 0.0.0.0; default gateway set to 0.0.0.0.

IP routes

No static routes configured.

Jumbo frame support

Enabled on all ports.

Link aggregation control 
protocol (LACP)

Enabled.

Link aggregation admin 
key

Set to 32768 for all ports.