Enterasys Networks D2G124-12P Benutzerhandbuch
D-Series CLI Reference 2-1
2
Basic Configuration
At startup, the D‐Series switch is configured with many defaults and standard features. This
chapter describes how to customize basic system settings to adapt to your work environment.
chapter describes how to customize basic system settings to adapt to your work environment.
Quick Start Setup Commands
The tables in this section provide a quick reference for the CLI commands needed to begin basic
D2 switch operation.
D2 switch operation.
lists tasks and their associated CLI commands required for setting
up the switch with the latest firmware.
lists optional CLI commands that will help you
perform additional basic configuration on the switch. Refer to the pages listed for more
information about each command.
information about each command.
For information about...
Refer to page...
Table 2-3 Required CLI Setup Commands
Step Task
CLI commands
Refer to
page...
page...
1
Set a new password.
set password [username]
2
Set the switch IP address.
set ip address ip-address [mask
ip-mask] [gateway ip-gateway]
ip-mask] [gateway ip-gateway]
3
Download, activate, and verify new
firmware on the switch using TFTP
copy.
firmware on the switch using TFTP
copy.
copy tftp://tftp_server_ip_address/
filename system:image
filename system:image
set boot system filename
show version