3com 3.01.01 Benutzerhandbuch

C

HAPTER

 8: STP O

PERATION

Perform the following configuration in system view. 

Perform the following configuration in Ethernet port view.

For more information about the commands, see the Switch 8800 Command 
Reference Guide. 

By default, MSTP is enabled on all the ports after it is enabled on the device. 

After you configure MSTP, execute the display command in all views to display 
the operation of the MSTP configuration, and to verify the effect of the 
configuration. Execute the reset command in user view to clear the statistics of 
MSTP module. Use the debugging command in user view to debug the MSTP 
module 

Table 24   Enable/Disable MSTP on a Port

Enable MSTP on a port.

stp interface interface-list enable

Disable MSTP on a port.

stp interface interface-list disable

Restore the default MSTP state on the port.

undo stp interface-list

Table 25   Enable/Disable MSTP on a Port

Enable MSTP on a port.

Disable MSTP on a port.

Restore the default MSTP state on the port.

Table 26   Display and Debug MSTP

Show the configuration information about the 
current port and the switch.

display stp instance instance-id [ interface 
interface-list ] [ brief ]

Show the configuration information about the 
region.

Clear the MSTP statistics information.

reset stp [ interface interface-list ]

Enable/Disable MSTP (packet 
receiving/transmitting, event, error) 
debugging on the port.

[ undo ] debugging stp [ interface 
interface-list ] { packet | event }

Enable/Disable the global MSTP debugging.

[ undo ] debugging stp { global-event | 
global-error | all }

Enable/Disable specified STI debugging

[ undo ] debugging stp instance instance-id