Epson MFJ-1278B Benutzerhandbuch

is proper Pactor etiquette.  If you access your Mailbox via the SYsop command, then 
you must issue a CTRL-C to exit the Mailbox and return to command mode.  The 
SYSOP mode is accessed through the Packet mailbox, as mentioned earlier in this 
section.  The command prompt will indicate the stream you are on. The command 
prompt may look like this: 

|Acmd:  where |A indicates that you are on packet stream A. 

To re-enter the Pactor mailbox you would type the following from the cmd: prompt: 

This is the only way the remote users can access your Mailbox. 

Upon accessing the mailbox this message will appear if there are any new messages are 
addressed following the last time you logged into the mailbox. 

You have mail! 

Upon access to a mailbox, this message will appear if there are messages addressed to you. 

This message occurs when a command issued is not understood by the mailbox.  This could 
be out of range slot number, missing slot number where one is required, or bad command. 

Cannot, not yours 

This message occurs when a remote user attempts to kill a message which is not his, or he 
tries to read personal message by or for someone else. 

?Mailbox full 

This message occurs when either all of the available slots are full, or the actual message 
space is full.  Messages must be killed to recover from this error. 

Not found 

This message occurs when one attempts to read or kill a non-existent message from an empty 
slot. 

None found 

A parameterless Kill or Read command did not find any messages addressed to the user. 

No mail