Extreme networks 12802 Benutzerhandbuch

Seite von 160
Installing or Removing an External Compact Flash Memory Card
 
BlackDiamond 12800 Series Switches Hardware Installation Guide
111
Installing or Removing an External Compact Flash 
Memory Card
You do not need to power off the system or remove the MSM from the chassis to install or remove an 
external compact flash memory card. 
You need an ESD-preventive wrist strap to install a compact flash memory card. 
To install the memory card:
1
Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground 
receptacle on the chassis front panel.
2
Locate the compact flash slot on the MSM, as shown in 
Figure 72: Typical Compact Flash Slot Location 
3
Hold the memory card between your thumb and forefinger, with the ridge facing toward the bottom 
of the chassis.
4
Slide the card into the compact flash slot until you feel resistance.; a portion of the card will 
protrude from the slot.
5
Carefully push the card until it is seated into the slot. The card should be fully inserted, or seated, 
inside the slot.
6
To verify that the card is fully seated, use the 
show memorycard
 command. 
To remove the external compact flash memory card:
1
Use the 
eject memorycard
 command to ensure that you will not lose any data when you remove 
the card. 
After you use the 
eject memorycard
 
command, you can physically remove the card from the 
external compact flash slot on the MSM. For more information about the 
eject memorycard
 
command, see the ExtremeXOS 12.0 Concepts Guide.
2
Attach the ESD-preventive wrist strap to your wrist and connect the metal end of the strap to the 
ground receptacle on the chassis front panel.
3
Locate the black release pin just above the compact flash slot.
4
Press the release pin until the card releases from the slot. 
The card releases to an intermediate position; the card remains partially inserted but is no longer 
seated in the slot.
5
Remove the card completely and place it in a safe location.
EX_183
Module status
LEDs
ERR
ENV
SYS
Reset
MSTR
Compact
flash
Console
port
MGMT port