Extreme networks 12802 Benutzerhandbuch

BlackDiamond 12800 Series Switches Hardware Installation Guide

The following tools, equipment, and resources are required for installing the BlackDiamond 12804 
chassis:

●

ESD-preventive wrist strap (provided)

●

19-inch helper bracket (provided)

●

For installing the chassis in a mid-mount position in the rack:

■

Optional BlackDiamond 8806/12804 mid-mount kit, part number 65046. Order this kit separately 
from the chassis.

■

#2 Phillips screwdriver

●

Rack-mount screws appropriate for your organization’s rack system, as follows:

■

4 screws to attach the helper bracket 

■

12 screws to secure the BlackDiamond 12804 chassis in the rack 

The screw size will vary based on your organization’s rack system; screws are not provided.

●

Screwdriver appropriate for the rack-mounting screws you will use

The screwdriver size will vary based on the requirements of your organization’s rack system.

To install the BlackDiamond 12804 switch in a mid-mount position in the rack, attach the optional mid-
mount brackets. 

To attach the mid-mount brackets:

Place the empty BlackDiamond 12804 chassis in an upright position on a secure flat surface.

Determine the locations for the mid-mount brackets.

Identify the left and right brackets. 

Each mid-mount bracket is clearly marked for placement on either the right or left side, as viewed 
from the front of the chassis.

On each side of the chassis, attach the appropriate mid-mount bracket using the eight screws 
provided in the kit (see