Sony 4-296-436-11 (2) Benutzerhandbuch

II-40

Overview

Chapter

  

C

h

ap
te

r 6

  

3D
 Sy
s

te

m

With this unit, you can create a 3D video signal by 
inputting a video for the left eye (L) and a video for the 
right eye (R) as a pair.
This chapter describes the connections and settings 
required for using the unit in a 3D system. 

When using the unit in a 3D system, make the following 
necessary connections and settings.

configuring a 3D system, see “Example 2: When 3D system” (page II-6) in 

The following restrictions apply when configuring a 3D 
system including the unit.
• Configure the 3D system with only one MCS-8M unit. 

Two units cannot be used linked together.

• When the unit is operated in a 3D system, only an HD 

(1080i/59.94, 1080i/50, 720p/59.94, or 720p/50) signal 
format can be used. If the signal format is changed from 
HD to SD, 3D mode is canceled.

• Audio embedded in HDMI inputs cannot be used.

• The connectors that can be used for 3D video input and 

the cross point buttons to which video signals can be 
assigned are fixed as shown below.

• The connectors to which 3D video output signals can be 

assigned are fixed as shown below.

• Use a reference signal to synchronize the images from 

the 3D video input device and this unit.

• The TALLY/GPI connector will be dedicated to 

TALLY. The TALLY will be fixed at IN1 (SDI IN 1, IN 
2) and IN2 (SDI IN 3, IN 4).

Connecting Each of the Devices (page II-6)

r

r

r

Confirming 3D Video Output (page II-42)

SDI IN 1

SDI 1 (L)

1

SDI IN 2

SDI 1 (R)

SDI IN 3

SDI 2 (L)

2

SDI IN 4

SDI 2 (R)

SDI OUT PGM

PGM (L)

SDI OUT AUX 1

PGM (R)

SDI OUT AUX 2

PGM (L+R)

Side by Side

SDI OUT MULTI VIEWER

Multi Viewer

DVI-D OUT AUX

PGM (L+R)

Side by Side

DVI-D OUT MULTI 
VIEWER

Multi Viewer