GE 45609 Benutzerhandbuch

5

One of the ways to wire a two-switch/one-load circuit is to route the 
incoming power through the first switch, then to the second switch 
and then to the load. Although very common and by no means a 
standard, it is the easiest to convert to Z-Wave control. With this 
type of circuit, Switch 1 is replaced by the Z-Wave auxiliary switch 
and Switch 2 is replaced with the primary Z-Wave switch. The auxil-
iary switch does not actually control the power; instead, it sends a 
momentary voltage signal through the traveler wire to the primary 
switch which in turn, controls the power to the load. 

 

This switch may be used in new installations or to replace an 
existing wall switch. It may be used by itself for 2-way control (one 
switch & one load), with one 45610 Auxiliary Switch for 3-way con-
trol (two switches & one load) or with two 45610 Auxiliary switches 
for 4-way control (three switches & one load). When used by itself 
for 2-way control, please make sure that the screw terminal for 
the traveler wire is insulated (Do Not Remove the tape over the 
terminal if you are not using the traveler connection).