Fortinet 5003 Benutzerhandbuch
FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
48
01-30000-85717-20081205
Fabric gigabit switching within a chassis
FortiGate-5050 fabric backplane communication
This section describes:
•
•
•
•
•
•
•
•
•
Fabric gigabit switching within a chassis
You can use FortiSwitch-5003A fabric channel switching for communication
between the fabric backplane interfaces of FortiGate-5001A or 5005FA2 boards
installed in a FortiGate-5050 chassis.
between the fabric backplane interfaces of FortiGate-5001A or 5005FA2 boards
installed in a FortiGate-5050 chassis.
shows a FortiGate-5050 chassis with a FortiSwitch-5003A board in
hub/switch slot 2, and FortiGate-5001A boards in slots 3, 4, and 5. In this
configuration the FortiSwitch-5003A board provides 1-gigabit fabric backplane
switching for the FortiGate-5001A fabric2 interfaces. The FortiSwitch-5003A
boards operate as layer-2 switches and the FortiGate-5001A boards operate as
typical standalone FortiGate units.
configuration the FortiSwitch-5003A board provides 1-gigabit fabric backplane
switching for the FortiGate-5001A fabric2 interfaces. The FortiSwitch-5003A
boards operate as layer-2 switches and the FortiGate-5001A boards operate as
typical standalone FortiGate units.
The chassis can be connected to the network using any of the FortiGate-5001A
front panel interfaces. You can also connect FortiSwitch-5003A front panel fabric
interfaces to the network. You can also install FortiGate AMC modules in the
FortiGate-5001A boards and connect the network to the AMC front panel
interfaces. The AMC modules and the network connections are not shown in
front panel interfaces. You can also connect FortiSwitch-5003A front panel fabric
interfaces to the network. You can also install FortiGate AMC modules in the
FortiGate-5001A boards and connect the network to the AMC front panel
interfaces. The AMC modules and the network connections are not shown in
.
Figure 16: FortiGate-5050 fabric channel 2 data communication
1
2
2
3
4
5
SMC
1
SMC
POWER
5050SAP
SERIAL
1
SERIAL
2
ALARM
10/100
link/Act
ETH0 Service
RESET
ST
ATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
10/100
link/Act
ETH0 Service
RESET
ST
ATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
Fabric channel 2
data communication
data communication