Fortinet 5003 Benutzerhandbuch

Use this command to change the administrative status of FortiSwitch-5003A fabric channel interfaces 
(bring each interface up or down) and configure each fabric channel interface to receive heartbeat 
packets from FortiGate-5001A or 5005FA2 fabric channel interfaces. 

config switch fabric-channel physical-port

end

edit <interface_name>

Enter the name of the FortiSwitch-5003A fabric channel 

interface to configure. You cannot configure physical port 

settings for a trunk. You can configure physical port settings for 

interfaces that have been added to a trunk.
For the fabric channel <interface_name> can be:
• slot-2/1 used to connect the fabric channels of two 

FortiSwitch-5003A boards installed in the same chassis.

• slot-3 FortiGate chassis slot 3.
• slot-4 FortiGate chassis slot 4.
• slot-5 FortiGate chassis slot 5.
• slot-6 FortiGate-5140 chassis slot 6.
• slot-7 FortiGate-5140 chassis slot 7.
• slot-8 FortiGate-5140 chassis slot 8.
• slot-9 FortiGate-5140 chassis slot 9.
• slot-10 FortiGate-5140 chassis slot 10.
• slot-11 FortiGate-5140 chassis slot 11.
• slot-12 FortiGate-5140 chassis slot 12.
• slot-13 FortiGate-5140 chassis slot 13.
• slot-14/f8 FortiGate-5140 chassis slot 14 or 

FortiSwitch-5003A front panel slot 14/F8.

• f7 FortiSwitch-5003A front panel slot F7.
• f6 FortiSwitch-5003A front panel slot F6.
• f5 FortiSwitch-5003A front panel slot F5.
• f4 FortiSwitch-5003A front panel slot F4.
• f3 FortiSwitch-5003A front panel slot F3.
• f2 FortiSwitch-5003A front panel slot F2.
• f1 FortiSwitch-5003A front panel slot F1.

heartbeat {disable | 
enable}

Enable or disable listening for heartbeat packets from 

FortiGate-5001A or 5005FA2 fabric interfaces. 
If you enable listening for heartbeat packets on interfaces 

added to link aggregation trunks the FortiSwitch-5003A board 

can detect if a FortiGate-5001A or 5005FA2 board is no longer 

available. You must configure the FortiGate-5001A or 5005FA2 

board to send heartbeat packets using the following 

FortiGate-5001A or 5005FA2 CLI command:

config system global

set fortiswitch-heartbeat enable

end

disable

status {down | up}

Bring the interface up or down. 

up