Fujitsu FD-1016AT Benutzerhandbuch

 

33 

 
The EDID Setting Mode may be ended as follows: 

Press the <P> key to return to the Server Selection screen. 

Press the <Esc> key to escape the Hot Key Mode and return to the normal console 

screen. 

 

EDID for 15" LCDs (Console Drawer) is set before the Console Drawer is 
shipped from the factory. 
When Console Drawer is used in a non-cascaded connection, EDID setting 
is not required. 
Set EDID when other monitors are connected to Console Drawer, or when 
a cascaded connection is made. 

 
 

 
The Console Drawer can be stored in the rack when a monitor and keyboard are not 
needed. 
 

 

Slide the Console Drawer in and out of the rack slowly. 
 

 
1. 

Push the monitor power button to turn off the power to the monitor. 

Hold the handle and slowly close the monitor. Be sure that the LCD lock catches. 

Push the locking springs on both sides of the slide rail and slide the Console Drawer 
into the rack. Be sure the latch lever catches. 

 
 

 

 

Be careful not to pinch your fingers or hands in the guide rails, slide 
rails, or the Console Drawer itself when storing the Console Drawer. If 
the latch lever is not set the Console Drawer may slide out if the rack is 
moved. 

 

 

We recommend turning off the monitor's power when it is not in use, to 

conserve electricity. Power is supplied to the keyboard and mouse even if 
power to Console Drawer is turned off. This does not cause any problems 
in server operation.