Fujitsu FS-1008MU Benutzerhandbuch

 

1 4  

3)  After each host and switch device have been connected, connect the keyboard, mouse, 

and monitor to the [CONSOLE] connectors on the switch device. 

4)  Attach switch device's AC power cable and then plug it into an electric outlet. 
5)  After confirming that the connections have been made correctly, start up the attached 

hosts. 

6)  Acquire Plug-n-Play data for the monitor. 

 When a monitor is first attached to the switch device, its Plug-n-Play data (EDID data) 
needs to be acquired by the switch device.  Re-start the host to be able to use the 
monitor with the acquired environment. 

[Plug-n-Play data setting] 
 After connect the monitor to the switch device, push reset_sw or open the OSD via 
the hot key press, then go to EDID setting mode (using NEXT PAGE), and press the 
Enter key. 

7)  Select each port  in turn  and confirm  the attached host is started up and using the 

correct settings. 

8)  If the keyboard, mouse, or  monitor is not set correctly,  adjust the settings and restart 

the system. 

1)  Connect the  hosts one  through eight to the second level of switch devices (called 

slaves), in the same way as for the [first level].   

2)  Next, use the special cables to attach the host port connector of the first level switch 

device (called master) to the [PS/2 keyboard], [PS/2 mouse], and [monitor] connectors 
on the console ports of the second level slave switch devices. 

3)  To increase the number of slaves, connect them in the same way as described in steps 

1 and 2 above. Do not connect slaves beyond the second level. Three level connection 
does not work. 

 

 

 
 
 

 

    
 
 
 

 
 
 

 

 

 

 

 
 

 

 

 

 
 

 

 

 

 

 

                                   

                    USB Keyboard, Mouse   

                                                                                     Monitor 

Second level 

(Slave) 

First level

(Master) 

d

d