Fujitsu FS-1004MU Benutzerhandbuch

 

1 5  

4)  After each host and switching device have been connected, connect the keyboard, 

mouse, and monitor to the [CONSOLE] connectors on the (master) switch device. 

5)  Attach switch device's AC power cable and then plug it into an electric outlet. 
6)  After confirming that the connections have been made correctly, start up the attached 

hosts. 

7)  Acquire Plug-n-Play data for the monitor. 

 When a monitor is first attached to the  master switch  device,  its  Plug-n-Play data 
(EDID data) needs to be acquired by the switch device. Re-start the host to be able to 
use the monitor with the acquired environment. 

[Plug-n-Play data setting] 
 After connect the monitor to the switch device, push reset_sw or open the OSD via 
the hot key press, then go to EDID setting mode (using NEXT PAGE), and press the 
Enter key. 

8)  Select each port  in turn  and confirm  the attached host is started up and using the 

correct settings. 

9)  If the keyboard, mouse, or monitor are not set correctly, adjust the settings and restart 

the system. 

 

 

 This switch device and the hosts should use a three-line type power cable, 
with the ground line on the power cable grounded. 
If  you  use  a  two-line  plug  adapter  be  sure  to  attach  the  ground  wire  to  a 

grounded object. 

  Only PS/2 cable is using to cascade connections. 
 Don’t connect USB devices to slave switch device. (Cascade connection will 
be lost when slave switch device has USB devices)