Fujitsu FS-1004MU Benutzerhandbuch

 

8  

 
 
 
 
 
 
 
                                        1)  4)  3)                                  2)   5)

 

 

               1)  4)      3)                        2)   5)

 

 

 

 

 

 

Lights up when the host is ON. And, flashes when internal power is low by disconnect 
an AC cord or blow an internal fuse. 

Press this  button when you want to automatically switch between host screens. 
Pressing it twice stops auto scan. The SELECT LEDs flash (slowly) in order during auto 
scan. Also, host operations cannot be performed at this time.   

Press a button to select its host. You can select hosts even if the POWER LED is not lit. 

Lights up when the host is selected. It flashes quickly when in the hot key mode.   

Normally, this switch is not used. Use this switch when selection is not possible or when 
the keyboard or mouse cannot be operated. Press it lightly with the tip of a metal pin or 
similar. Pressing this switch returns  the switch device to its initial state, and hosts can 
be restored without being rebooted. If you are using USB or Sun serial interfaces, you 
can reset the interface by holding the reset switch down for over five seconds.