Fujitsu XG2600 Benutzerhandbuch

XG2600 Hardware Guide

Chapter 2 Installation

Installation of the switch

2.2.3

Change Switch Access Configurations from Rear-Access
(Factory Default) to Front-Access and Install

This section describes how to change Rear-Access configuration (Factory Default) to Front-Access.

Remove rack mounting brackets

Remove rack mounting brackets attached to the sides of the switch.

Change the direction of fans to adjust airflow

Change the direction of fans, depending on which switch access configuration to go with, Rear-Access or Front-Access.
Check the direction of fans before installing the switch in the rack.

Airflow is as shown below.

•

Rear-Access Configuration (Factory Default)

•

Front-Access Configuration

Note

For Front-Access configuration to Rear-Access, make the procedure reversed.

Rack Mounting Clamps

XG2600

Intake

Airflow Label

Exhaust

Airflow Label

Intake