Avaya 882 Benutzerhandbuch
User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
A-1
A
Upgrading the Application
Software
Software
CAUTION:
Overview
Upgrading the switch software involves the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
This appendix contains procedures for each of these steps.
Before downgrading the switch from v6.x application software to
v5.x, you must initialize NVRAM (nvram initialize command). If you
do not initialize NVRAM before downgrading the application
software, the switch may not respond after you reset it.
v5.x, you must initialize NVRAM (nvram initialize command). If you
do not initialize NVRAM before downgrading the application
software, the switch may not respond after you reset it.
If the switch has multiple VLANs statically bound to hunt group ports, and
you upgrade from application software earlier than v5.3, you must delete
the hunt groups and set them up again. For information on how to perform
this task, see “
you upgrade from application software earlier than v5.3, you must delete
the hunt groups and set them up again. For information on how to perform
this task, see “
” later in this appendix.
For more information about the CLI commands that are mentioned in this
appendix, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.1
appendix, see Command Reference Guide for the Avaya P580 and P882
Multiservice Switches, Software Version 6.1