Brocade Communications Systems 53-1001761-01 Benutzerhandbuch

Default ACL configuration

8

•

VLANs

Default ACL configuration

 lists the default ACL configuration.

ACL configuration guidelines and restrictions

Follow these ACL configuration guidelines and restrictions when configuring ACLs:

•

The order of the rules in an ACL is critical. The first rule that matches the traffic stops further 
processing of the frames.

•

Standard ACLs and extended ACLs cannot have the same name.

ACL configuration and management

You need to enter either the copy running-config startup-config command or the write memory 
command to save your configuration changes to Flash so that they are not lost if there is a system 
reload or power outage.

NOTE
To see the minimum configuration required to enable FCoE on the Brocade 8000 switch, refer to 

 on page 29.

Creating a standard MAC ACL and adding rules

NOTE
You can use the resequence command to change all the sequence numbers assigned to the rules 
in a MAC ACL. For detailed information, see 

To create a standard MAC ACL and add rules, perform the following steps from Privileged EXEC 
mode.

1. Enter the configure terminal command to access global configuration mode.

2. Create a standard MAC ACL and enter ACL configuration mode. 

In this example, the name of the standard MAC ACL is “test_01.”

switch(config)#mac access-list standard test_01

switch(conf-macl-std)#

TABLE 14

Default MAC ACL configuration

Parameter Default 

setting

MAC ACLs

By default, no MAC ACLs are configured.