Meridian America 61 Benutzerhandbuch
7 1
Cabling
The cables are differentiated by the cabling method used. Two types of
cables are available.
Intra-UEM cables are cables that connect to different cards within a UEM,
or cables that go to the I/O connector panels at the rear of the UEM.
or cables that go to the I/O connector panels at the rear of the UEM.
Intra-UEM cables are not shielded. These cables arc typically round and
use bail locks or screws to prevent accidental removal.
use bail locks or screws to prevent accidental removal.
Inter-UEM cables are cables that are routed internally between
These cables are used primarily for interconnecting the following
subsystems together:
These cables are used primarily for interconnecting the following
subsystems together:
CPU
CPU to Network
Network to Network
Network to Peripheral Equipment
All of the faceplate connectors use a
cable egress and all of the
backplane connectors use a
cable egress.
module-to-module power harness
Purpose-This power wiring harness is used in DC modules to connect the
input DC power and speed control signals vertically through the column. It
is constructed in a modular form, and can be disconnected when necessary
to allow for the removal and/or replacement of modules. The DC power
harness is larger than that of the AC system since it requires the use of more
input wires in order to handle the lower voltage and its associated higher
current.
input DC power and speed control signals vertically through the column. It
is constructed in a modular form, and can be disconnected when necessary
to allow for the removal and/or replacement of modules. The DC power
harness is larger than that of the AC system since it requires the use of more
input wires in order to handle the lower voltage and its associated higher
current.
Equipment identification and ordering information 553-3001-154