Lucent Technologies P332MF Benutzerhandbuch
Cajun P332MF User’s Guide
113
Installing the Expansion Sub-module in the Cajun P330
1
Remove the blanking plate or other sub-module (if installed).
2
Insert the sub-module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails.
The PCB not the metal base plate fits into the guide rail.
Board (PCB) is aligned with the guide rails.
The PCB not the metal base plate fits into the guide rail.
3
Press the sub-module in firmly until it is completely inserted into the
Cajun P330.
Cajun P330.
4
Gently tighten the two screws on the front panel of the expansion sub-module
by turning the screws.
by turning the screws.
Note: The expansion sub-modules contain components sensitive to electrostatic
discharge. Do not touch the circuit board unless instructed to do so.
discharge. Do not touch the circuit board unless instructed to do so.
Removing an Existing Expansion Sub-module
1
1
Loosen the screws by turning the knobs.
2
Grasp the two knobs one near each side of the front panel, and pull gently but
firmly towards yourself.
firmly towards yourself.
3
Insert another expansion sub-module or the blanking plate.
Note: The Cajun P330 switch must not be operated with the expansion slot open;
the expansion sub-module should be covered with the supplied blanking plate if
necessary.
the expansion sub-module should be covered with the supplied blanking plate if
necessary.
Note: X330GT2 sub-modules are hot swapable and can be inserted or removed in
an operating base unit.
an operating base unit.
Cabling
A Category 5 copper cable with RJ-45 termination should be used. You should use
all eight wires in the cable.
all eight wires in the cable.
The maximum copper cable length connected to a 1000Base-T port is 100 m
(328 ft.)
(328 ft.)