Delta Electronics RTU-EN01 Benutzerhandbuch

DVP-PLC Operation Manual 

25

You can move the IF-THEN setting upwards or downwards to change the execution order of them.

6.8 Smart PLC Setting: Timer 

RTU-EN01 has the independent Smart PLC function. The timer is able to time following the system time. There 

are 16 timers in RTU-EN01. The timing range is 10ms ~ 655,35s.

 

„

 Timer 

 

 

 

1. Enable: 

Decide whether to enable the timer in this column. 

2. Cyclic: 

Decide whether to reset the timer and re-start the timing when the timing reaches the target in this 

column. 

3. Reset 

when 

STOP->RUN: 

Decide whether to reset the timer when the system goes from STOP to RUN. 

4. Timeout 

bound: 

The time for the timer to reach the target. Range: 10ms ~ 65,535s. 

6.9  Smart PLC Setting – Counter 

RTU-EN01 has the independent Smart PLC function. The counter can be triggered by the external input points 

RX. When RX turns from OFF to ON, the counter will start to count. There are 16 counters in RTU-EN01, 

responsible for counting up and counting down. The counting range is -32,768 ~ 32,767.

 

„

 Counter