Minicom Advanced Systems DX User IP Benutzerhandbuch
USER GUIDE
44
Key length - Length of the generated key in bits. 1024 Bits are supposed be
sufficient for most cases. Larger keys may result in slower response time during the
connection.
sufficient for most cases. Larger keys may result in slower response time during the
connection.
3. Click
.
4. Press Download CSR to download the CSR to your administration machine.
5. Send the CSR to a CA for certification. They will send a new certificate
6. Press Upload to upload the certificate to DX User IP. The certificate uploads.
Important! If you destroy the CSR on DX User IP there is no way to get it back! If
you deleted it, repeat the above steps.
you deleted it, repeat the above steps.
Telnet Settings
Enable Telnet access - Access over Telnet client. For better security disable Telnet
access.
Enable Telnet access - Access over Telnet client. For better security disable Telnet
access.
IP Access Control
This is used to limit access to a specific number of clients only. These clients are
identified by their IP addresses.
This is used to limit access to a specific number of clients only. These clients are
identified by their IP addresses.
The IP access control settings apply to the LAN interface only!
Enable IP Access Control - Enables access control based on IP source addresses.
Default policy - Controls arriving IP packets that don't match any of the configured
rules. They can be accepted or dropped.
rules. They can be accepted or dropped.
ATTENTION: If you set this to DROP and you have no ACCEPT rules configured,
access to the Web front-end over LAN is disabled! To enable access, change the
security settings via modem dial in or by temporarily disabling IP access control
with the initial configuration procedure (see page 11).
access to the Web front-end over LAN is disabled! To enable access, change the
security settings via modem dial in or by temporarily disabling IP access control
with the initial configuration procedure (see page 11).
Rule # - Type the rule number for which the following commands will apply. This is
ignored, when adding a new rule.
ignored, when adding a new rule.
IP/Mask - Specifies the IP address or IP address range for which the rule applies.
Numbers attached to an IP address with a `/' is the number of valid bits that are used
for the given IP address. Examples:
for the given IP address. Examples:
192.168.0.22 or 192.168.0.22/32 matches the IP Address 192.168.0.22.
192.168.0.0/24 matches all IP packets with source addresses from 192.168.0.1 to
192.168.0.254.
192.168.0.254.